Connecting a Scan-X Color scanner

Article View: comp.sys.next.hardware

Article #807

Back to comp.sys.next.hardware Previous Next

#807

From: Stuart Pearlman
Date: Fri, 09 Oct 1992 16:42

22 lines
1244 bytes

Is it possible to daisy-chain another scsi device off of a Scan-X
Color scanner?  The scanner only has one scsi connector on the back,
so it appears that it must be the last device on the scsi chain.  

The manual states that it can go anywhere in the scsi chain, and
discusses under what circumstances the scanner needs a terminator
(basically, if it is the last device in the scsi chain).

If you can put the scanner in the middle of the scsi chain, how would
you daisy-chain the subsequent device?

If you put it at the end of the scsi chain, what's the correct way to
connect the terminator?

Thanks in advance.

-stuart
-- 
Stuart Pearlman                                 stuart@oasys.dt.navy.mil
Trandes Corporation                             +1 301 459 0200
On-Contract-To: David Taylor Research Center    +1 301 227 1428

Technical Details

Message-ID: <26251@oasys.dt.navy.mil>

Path: arc1-ca.pugleaf.net!sparky!uunet!ukma!darwin.sura.net!dtix!oasys!stuart

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!sparky!uunet!ukma!darwin.sura.net!dtix!oasys!stuart
From: stuart@oasys.dt.navy.mil (Stuart Pearlman)
Newsgroups: comp.sys.next.hardware
Subject: Connecting a Scan-X Color scanner
Message-ID: <26251@oasys.dt.navy.mil>
Date: 9 Oct 92 16:42:43 GMT
Organization: Carderock Division, Naval Surface Warfare Center
Lines: 22
X-Organization: (formerly David Taylor Research Center)