SUPRA 9600 baud

Thread View: comp.sys.next.misc

3 messages

[T] Back to Threads [V] Tree View [G] Group Articles

3 total messages Started by Rich Trott Sat, 11 Apr 1992 23:08

#1332

Author: Rich Trott
Date: Sat, 11 Apr 1992 23:08

13 lines
658 bytes

Do these modems work right out of the box, or do you need to make one
of the funky cables described in the zs man page?

Please respond via posting, as email is on the fritz (or on the
upgrade, more accurately).

thanks,

rich
-- 
Rich Trott
trott@remus.rutgers.edu

Re: SUPRA 9600 baud

#1335

Author: Jess Anderson
Date: Sat, 11 Apr 1992 23:44

17 lines
1268 bytes

In article <Apr.11.19.08.10.1992.14151@remus.rutgers.edu>
trott@remus.rutgers.edu (Rich Trott) writes:

>Do these modems work right out of the box, or do you need to make one
>of the funky cables described in the zs man page?

Assuming the modem has (Supra does) a standard RS232 DB25
connector, you can buy the correct cable, wired as required
by the zs man page.  We sell the right cable where I work; I
think it was $9.50.

-- 
Jess Anderson <> Madison Academic Computing Center <> University of Wisconsin
Internet: anderson@macc.wisc.edu <-best, UUCP:{}!uwvax!macc.wisc.edu!anderson
NeXTmail w/attachments: anderson@yak.macc.wisc.edu  Bitnet: anderson@wiscmacc
Room 3130 <> 1210 West Dayton Street / Madison WI 53706 <> Phone 608/262-5888

Re: SUPRA 9600 baud

#1420

Author: Mike Henry
Date: Mon, 13 Apr 1992 09:25

22 lines
1608 bytes

In article <1992Apr11.234408.13960@macc.wisc.edu> anderson@macc.wisc.edu (Jess Anderson) writes:
>In article <Apr.11.19.08.10.1992.14151@remus.rutgers.edu>
>trott@remus.rutgers.edu (Rich Trott) writes:
>
>>Do these modems work right out of the box, or do you need to make one
>>of the funky cables described in the zs man page?
>
>think it was $9.50.

I had a hard time finding a cable I could trust so, yes, I made one myself for
my SupraFAX. I just hooked it up and it ran great the first time. However, tip
left more than a little to be desired, but SLIP ran great the first time.
Cost $5<, but you need a steady hand soldering the MiniDIN-8. B^)

>Jess Anderson <> Madison Academic Computing Center <> University of Wisconsin

		-Mike
-- 
Mike Henry                    INET : mikhe@cs.uoregon.edu              ///
441 E 13th St. #2                    mikhe@ida.liu.se                 ///
Eugene, OR. 97401                                                 \\\///
USA                           TEL  : +1 (503) 344-5122             \XX/

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads