🚀 go-pugleaf

In article <1992Oct5.184251.11901@cs.tu-berlin.de>  
gonzo@opal.cs.tu-berlin.de (S. F. Ruehauf) writes:
> A friend of mine just bought a Fijutsu disk.
> Its a Fijutsu M2624 FA 520MB, new.
> 
> Please, when you have a Fijutsu, help him on the way

For this disk, use the following jumper settings:
on jumper set CNH1, make sure that the following pairs of pins are  
open, and all other pairs are shorted:
 15-16
 23-24
 5-6

(15 and 16 disables SCSI synchronous mode, and 23-24 tells the drive  
to supply termination).  

To set SCSI ID, use CNH7, jumpers 1-2, 3-4, 5-6 as follows
ID   5-6   3-4   1-2
0     O     O     O
1     O     O     S
2     O     S     O
3     O     S     S
(for 4-7, repeat the previous, but short 5-6 also.)
key:  O:  pins open   S: pins shorted

To disable the internal termination, remove the gray part labeled  
RM85.

This should work for fujitsu M242x scsi disks, i know it works for  
the 2624.

as an aside fujitsu's tech support is good (at least here in the US).   
--
dan pritts                consultant/system administrator
dan.pritts@umich.edu      um itd/css unix support group 
313/998-6265