Re: ZyXEL : How does one adjust DTE rate for incoming calls ?

Article View: comp.sys.next.sysadmin

Article #59

Back to comp.sys.next.sysadmin Previous Next

#59

From: felix.lugo
Date: Sat, 31 Oct 1992 15:29

25 lines
1314 bytes

In article <1992Oct31.124117.2323@cs.tu-berlin.de> ernst@opal.cs.tu-berlin.de (Ernst Kloecker) writes:
|
| But how come the ZyXEL initiates the communication with 38400 ? I never
| told it to do so and I don't know how to, either. I know about the 
| AT&B0 setting, but that only locks the DTE rate and does not set it.
| And I also cannot set the register S20 manually !
| 
| Does anybody know how to set the DTE rate for incoming calls ?
| 
| Or is there a better getty for the NeXT ?

	Getty is fine, this is what needs to be done:

	- Bit 3 of s38 should be set to 1 (i.e., ats38=8)
	- s18 should be set to the "getty/dte" speed you want to match
	  (note: there are other values for different speeds)
		2:	38400
		3:	19200
		7:	9600

	Another useful setting is s40=1 (to disable throughtput averaging)

	Make sure you "ATW0" and "ATZ0" to make these changes permanent!

--Felix

Technical Details

Message-ID: <1992Oct31.152930.20608@cbnewsl.cb.att.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!wupost!usc!rpi!uwm.edu!linac!att!cbnewsm!cbnewsl!coco

References: <1992Oct31.124117.2323@cs.tu-berlin.de>

Show Full Headers

Complete Article Headers

Newsgroups: comp.sys.next.sysadmin
Path: arc1-ca.pugleaf.net!sparky!uunet!wupost!usc!rpi!uwm.edu!linac!att!cbnewsm!cbnewsl!coco
From: coco@cbnewsl.cb.att.com (felix.lugo)
Subject: Re: ZyXEL : How does one adjust DTE rate for incoming calls ?
Organization: AT&T
Date: Sat, 31 Oct 1992 15:29:30 GMT
Message-ID: <1992Oct31.152930.20608@cbnewsl.cb.att.com>
References: <1992Oct31.124117.2323@cs.tu-berlin.de>
Lines: 26

Reply to Parent Message