Next and Taylor UUCP

Thread View: comp.sys.next.sysadmin

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Eric Wampner Tue, 24 Nov 1992 00:34

#1955

Author: Eric Wampner
Date: Tue, 24 Nov 1992 00:34

13 lines
901 bytes

Okay, i am running 2.1, with 040 Next Cube.

Has anyone gotten taylor uucp 1.03 to compile properly on the next?

I compiled it without much trouble, but the trouble is that uucico 
does not seem to release the port after a caller has finished the
transaction (calling in). uucp works fine, but it takes a reboot
to fix the port. its not LockFiles, I looked in Debug (with all
enabled) and I don't see any messages about Closing or Reseting
the Port. So, is there a fix?

eric wampner
wampner@acme.ucf.edu

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads