GNU software on Dynix

Thread View: comp.sys.sequent

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Bruce Albrecht Thu, 25 Apr 1991 04:15

#548

Author: Bruce Albrecht
Date: Thu, 25 Apr 1991 04:15

8 lines
800 bytes

I suppose I should post this to the GNU newsgroups, but I don't get them.  I'm
having difficulty compliling gas, g++, binutils, fileutils and cvs on Dynix 3.0.17.
Has anyone successfully compiled (and used) all of this stuff?  Any hints?  Do
you know if things fall apart when upgrading to Dynix 3.1?  Thanks.
--


bruce@zuhause.mn.org    or    bruce@speeds01.zuhause.mn.org

Re: GNU software on Dynix

#561

Author: Zdzislaw Meglicki
Date: Wed, 22 May 1991 06:00

16 lines
1470 bytes

In article <bruce.0339@zuhause.MN.ORG>, bruce@zuhause.MN.ORG (Bruce Albrecht) writes:
|> I suppose I should post this to the GNU newsgroups, but I don't get them.  I'm
|> having difficulty compliling gas, g++, binutils, fileutils and cvs on Dynix 3.0.17.
|> Has anyone successfully compiled (and used) all of this stuff?  Any hints?  Do
|> you know if things fall apart when upgrading to Dynix 3.1?  Thanks.

I have the full GNU suite installed under DYNIX 3.0.17.9. I had to make a lot
of changes though. I am planning writing an extensive report. In the meantime
sys-admins fighting with GNU under DYNIX are welcome to have a look at my
installations and sources. 
-- 
   Gustav Meglicki, gustav@arp.anu.edu.au,
   Automated Reasoning Project, RSSS, and Plasma Theory Group, RSPhysS,
   The Australian National University, G.P.O. Box 4, Canberra, A.C.T., 2601, 
   Australia, fax: (Australia)-6-249-0747, tel: (Australia)-6-249-0158

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads