Gnu Emacs 18.52 + X11

Thread View: comp.sys.sequent

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Gary Erickson Tue, 31 Jan 1989 22:12

#747

Author: Gary Erickson
Date: Tue, 31 Jan 1989 22:12

16 lines
977 bytes

Could someone point me to the fix for gnu emacs 18.52 so that it
works under X11 on a Sequent Symmetry system.

I've got the problem where input to the emacs window isn't
printed until a ^C is done in the window envoking emacs.

Thanks

Gary
University of California Irvine        | (714) 856-4222
Information & Computer Science Dept.   | erickson@ics.uci.edu    (Internet)
Support Group                          | ucbvax!ucivax!erickson      (UUCP)
                                       | saericks@uci              (Bitnet)
-- 
Gary Scott Erickson

Re: Gnu Emacs 18.52 + X11

#748

Author: Mike Spitzer
Date: Wed, 01 Feb 1989 00:21

16 lines
977 bytes

In article <6431@paris.ics.uci.edu> erickson@paris.ics.uci.edu () writes:
>
>I've got the problem where input to the emacs window isn't
>printed until a ^C is done in the window envoking emacs.
>

This appears to be a generic problem with X11 emacs, not just on the
Symmetry.  Put the following in your .emacs:

(set-input-mode nil t)

and all will be fine.  BTW, I had to compile emacs on the Symmetry
without -O, apparently because of a bug in c2.  If you still have
problems, check to see if you compiled emacs with optimization.

		-mjs

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads