🚀 go-pugleaf

Here at AEDC we use gnuplot on several different platforms.  It has performed
great on all platforms thus far, until we tried to use it on an Indigo with
8bit graphics.  I have compiled both the IRIS4D and the X11 versions and both
have the same actions.  The plots seem to work fine with the exception of the
axes not displaying on either the X11 or IRIS4D version.  Anyone got gnuplot
running on an 8bit Indigo?  If so, what changes did you have to make?

Here is my hinv listing:
1 33 MHZ IP12 Processor
FPU: MIPS R2010A/R3010 VLSI Floating Point Chip Revision: 4.0
CPU: MIPS R2000A/R3000 Processor Chip Revision: 3.0
On-board serial ports: 2
Data cache size: 32 Kbytes
Instruction cache size: 32 Kbytes
Main memory size: 16 Mbytes
Integral Ethernet: ec0, version 0
CDROM: unit 4 on SCSI controller 0
Tape drive: unit 3 on SCSI controller 0: DAT
Disk drive / removable media: unit 2 on SCSI controller 0: 720K/1.44M floppy
Disk drive: unit 1 on SCSI controller 0
Integral SCSI controller 0: Version WD33C93B, revision C
Iris Audio Processor: revision 10
Graphics board: LG1

Thanks for any info.

 ____________________________________________________________________________
 \____________________________________________________________________________
 \_         Kenneth M. McDonald           \_                                \_
 \_         Systems Programmer            \_     Voice (615) 454-3413       \_
 \_ Arnold Engineering Development Center \_      Fax (615) 454-6171        \_
 \_       EAF Bldg * 1103 Avenue B        \_    mcdonald@aedc-vax.af.mil    \_
 \_       Arnold AFB, TN 37389-1200       \_                                \_
 \________________________________________\_________________________________\_
 \____________________________________________________________________________