Article View: comp.sys.sun.hardware
Article #2336Re: Standing the pizza box on end
From: David L Kindred (Dave)
Date: Mon, 11 Jan 1993 21:05
Date: Mon, 11 Jan 1993 21:05
28 lines
1723 bytes
1723 bytes
In article <C0Io11.My9@ccu.umanitoba.ca> mdoob@ccu.umanitoba.ca (Michael Doob) writes: Are there any problems running a sparc2 with pizza box in vertical position? Presumably the fan exhausting out the top would satisfy the cooling requirements. What about the hard disk? Anyone tried it? Michael All of the disk drives that I have seen specify that they should not be run in the cable-end up orientation. Most (if not all) should also not be run in the cable-end down orientation. Some will also specify that they not be run with one of the long sides up. This won't cause a problem, since that orientation would be the one you get with the pizza box upside down. The result of all of the above is that the 3/80 pizza box can be stood on it's feet, or on either side, but not on it's front or top. I have not seen the Sparc 2 pizza box, but assume that the disk orientation is the same. If they are, the fan exhausting out the "top" is not a good position. - Dave -- EMail: kindred@telesciences.com CI$: 72456,3226 (72456.3226@compuserve.com) Phone: +1 609 866 1000 x222 Snail: TeleSciences C O Systems, 351 New Albany Rd, Moorestown, NJ 08057-1177
Technical Details
Message-ID:
<KINDRED.93Jan11160503@pyrite.telesciences.com>Path:
arc1-ca.pugleaf.net!sparky!uunet!psinntp!telesci!kindredReferences:
<C0Io11.My9@ccu.umanitoba.ca>Show Full Headers
Complete Article Headers
Newsgroups: comp.sys.sun.hardware Path: arc1-ca.pugleaf.net!sparky!uunet!psinntp!telesci!kindred From: kindred@telesciences.com (David L Kindred (Dave)) Subject: Re: Standing the pizza box on end In-Reply-To: mdoob@ccu.umanitoba.ca's message of Fri, 8 Jan 1993 03:51:01 GMT Message-ID: <KINDRED.93Jan11160503@pyrite.telesciences.com> Sender: news@telesciences.com Nntp-Posting-Host: pyrite Organization: Telesciences CO Systems, Inc. References: <C0Io11.My9@ccu.umanitoba.ca> Date: Mon, 11 Jan 1993 21:05:03 GMT Lines: 28