🚀 go-pugleaf

"Michael Brown" <see@signature.below> writes:

>I've got an Ultra 2 with two 296MHz modules in it at the moment. A couple of 
>450MHz modules have popped up on ebay (pulls from a E420R). I know these 
>aren't supported in the Ultra 2, but is there a possibility of them working 
>(albeit at 400MHz due to the lower system bus speed)? The 33% boost in MHz 
>and the doubling of the cache should kick the overall performance up a notch 
>or two ...

Depends on how they'd be affected by the timing constraints - I've never
(yet!) tried a 450 Mhz module in an Ultra 2.

There isn't a jumper setting to correctly set the clock divisor for 450 Mhz
modules, but 450's will work fine in Ultra 60's and 80's (and the other
systems built around the U60 and U80 system boards) so they're useful to
have.

You could try a 450 Mhz module with each of the jumper settings for J2301 on
the Ultra 2 system board and see what happens. If you get a combination
which works the CPU might not run at the full rated speed.

Good luck!

Regards,

Craig.
-- 
Post by Craig Dewick (tm). Web --> "http://lios.apana.org.au/~cdewick".
Email me at "cdewick@poison.lios.apana.org.au". Explore my public-domain Sun
Microsystems technical data archive at "http://www.sunshack.org". Sun Micro
enthusiasts/users webring at "http://n.webring.com/hub?ring=sunmicrosystemsu".