🚀 go-pugleaf

In <577os4$flf@isis.fiu.edu> edmondsc@serss1.fiu.edu (Christopher A. Edmonds) writes:

>I just recently put a Sparc2 motherboard in a 3/80 case, it fits perfectly except
>for the plastic piece on the back, since the cutouts for the various expansion
>connectors are different. The setup has no internal hard drive, 64 MB RAM, and
>a floppy. So far I have had no problems.

Just remove the plastic piece from the back and forget about it. I've
installed some SS1/1+ boards in old 3/80 cases (same Campus-1 case as the
SS1 and SS1+ but with a different plastic piece on the back) and things work
fine.

>So... has anyone HAD problems with this setup? Cooling, power supply, etc. Please
>let me know.

You might find that an SS2 board will run fairly hot in a Campus-1 case
because the SS2 case was a slightly different design from the 3/80, SS1,
SS1+ design to allow for additional cooling. Otherwise there shouldn't be
any problems.

Regards,

Craig.
-- 
            Craig Dewick. Send email to 'cdewick@lios.apana.org.au'
   Point a web browser at 'http://lios.apana.org.au/~cdewick/sun_ark.html' to
       access my collection of Sun information and links to other places.