Article View: comp.sys.sun.hardware
Article #3322Re: Need to know--how to pull 30-pin simms in ss1, ipc
From: Craig Dewick
Date: Tue, 04 Jun 1996 00:00
Date: Tue, 04 Jun 1996 00:00
26 lines
1749 bytes
1749 bytes
In <4ouuf7$45d@mksrv1.dseg.ti.com> rjmyers@ti.com (Bob Myers) writes:
>What's the best way of pulling 30-pin simms out of
>IPCs or SS1s? I don't have the extraction tool that's
>shown in the Answerbook for doing this. I've also tried
>contacting a few electronics stores here in Dallas -- none
>of them ever heard of an extraction tool for 30-pin simms.
I have two alternative tools for extracting SIMM's. One is a sheetmetal
scribing tool which has a 90 degree bend at one end. Insert the tip in the
hole in the SIMM's PCB, and use the bend to provide leverage against the
plastic of the socket. Do this at both ends and voila! One removed SIMM!
The other tool is a very small metal kitchen skewer. Since it's so small,
it's easy to use in tight locations.
Regards,
Craig.
--
Craig Dewick - craig@zeta.org.au - http://www.zeta.org.au/~craig
Located in Sydney, Australia.
Sun Ripened Kernels - http://www.zeta.org.au/~craig/srk.html
Surplus and pre-loved Sun Microsystems equipment.
Technical Details
Message-ID:
<4p07u4$9nu@godzilla.zeta.org.au>Path:
arc1-ca.pugleaf.net!unknown!not-for-mailReferences:
<4ouuf7$45d@mksrv1.dseg.ti.com>Show Full Headers
Complete Article Headers
X-Google-Language: ENGLISH,ASCII-7-bit X-Google-Thread: f4671,3165e6665f7140e6 X-Google-Attributes: gidf4671,public X-Google-Thread: 10d053,433f2b4b62b7a5c1,start X-Google-Attributes: gid10d053,public X-Google-Thread: 1070f0,3165e6665f7140e6 X-Google-Attributes: gid1070f0,public From: craig@zeta.org.au (Craig Dewick) Subject: Re: Need to know--how to pull 30-pin simms in ss1, ipc Date: 1996/06/04 Message-ID: <4p07u4$9nu@godzilla.zeta.org.au> X-Deja-AN: 158330909 references: <4ouuf7$45d@mksrv1.dseg.ti.com> organization: Kralizec Dialup Unix Sydney, +61-2-837-1183 V.32bis newsgroups: comp.sys.sun.hardware,comp.sys.sun.admin,aus.computers.sun