SCSI Address Change ?

Article View: comp.sys.sun

Article #13720

#13720

From: Bob Kaser
Date: Fri, 09 Feb 1990 16:21

17 lines
1276 bytes

I have a SUN 3/60 with a Micropolus 1355, 141 M, disk drive attached to
the SCSI bus.  I also have a Micropolus 1325,71 M,disk that I would like
to connect to the 1355's SCSI out port.  The Micropolus 1325 has an
Adaptec(SP) controller.

When we originally purchased this drive we recieved no documentation on
it.  What I need to know is: 1)  How do I change the SCSI address to 'sd1'
or 'sd2' on the Adaptec(SP) controller.  2)  Along with this is,  which
jumper block do I change since I don't have any doc's on the drive.

  Thanks to all in advance.  
  Please email the results directly to me.

Why did the Lord give us so much  	 {)    kaser@ee.rochester.edu
quickness of movement unless it		//\\   {ames,cmcl2,columbia,cornell,
was to avoid responsibility with?      ///\\\  garp,harvard,ll-xn,rutgers}!
					 /\    rochester!ur-valhalla!kaser

Technical Details

Message-ID: <4877@brazos.Rice.edu>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!rice!sun-spots-request

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!rice!sun-spots-request
From: kaser@ee.rochester.edu (Bob Kaser)
Newsgroups: comp.sys.sun
Subject: SCSI Address Change ?
Keywords: Hardware
Message-ID: <4877@brazos.Rice.edu>
Date: 9 Feb 90 16:21:04 GMT
Sender: root@rice.edu
Organization: Sun-Spots
Lines: 17
Approved: Sun-Spots@rice.edu
X-Sun-Spots-Digest: Volume 9, Issue 32, message 16