Re: 3/80 SCSI cables

Article View: comp.sys.sun

Article #1669

#1669

From: Jon Mandrell
Date: Thu, 28 Sep 1989 19:51

20 lines
1349 bytes

>>  +------------------------+------+  <= ribbon cable
>>  |                        |      |
>>  |                        |      header, connect to internal drive
>>  |                        header, connect to board
>>  Old-style Sun connector, connect to shoebox cable
>On a related issue:  the docs I've seen say that mixing embedded and
>adaptec/emulex SCSI drives on the same 3/80 is "not supported".  Any ideas
>on what this really means?  If you try, do you get even stranger unit
>numbers than before?

I have not had a problem at all.  The ID's came up the same as on the
old 3/50 and 3/60 that I used before.  The drives are as follows:

	drive sd0 - SCSI ID 0
	drive sd2 - SCSI ID 1
	drive sd4 - SCSI ID 2
	drive sd6 - SCSI ID 3
	drive st0 - SCSI ID 4

Jon Mandrell, Applied Microsystems Corp., (jon@amc.com or ..!uunet!amc-gw!jon)

Technical Details

Message-ID: <1808@brazos.Rice.edu>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!attcan!uunet!ginosko!gem.mps.ohio-state.edu!tut.cis.ohio-state.edu!mailrus!cornell!uw-beaver!rice!sun-spots-request

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!attcan!uunet!ginosko!gem.mps.ohio-state.edu!tut.cis.ohio-state.edu!mailrus!cornell!uw-beaver!rice!sun-spots-request
From: amc-gw!jon@entropy.ms.washington.edu (Jon Mandrell)
Newsgroups: comp.sys.sun
Subject: Re: 3/80 SCSI cables
Keywords: Hardware
Message-ID: <1808@brazos.Rice.edu>
Date: 28 Sep 89 19:51:14 GMT
Sender: root@rice.edu
Organization: Sun-Spots
Lines: 20
Approved: Sun-Spots@rice.edu
X-Sun-Spots-Digest: Volume 8, Issue 145, message 1 of 14