TI MicroLaser Hookup

Article View: comp.sys.sun

Article #6821

#6821

From: Jeffrey Marans
Date: Wed, 13 Feb 1991 22:03

15 lines
1065 bytes

I queried the net about hooking a TI microlaser printer to an SS1 and
finally was able to use the Transcript supplied printcap, a 4 wire null
modem cable [1 - 1, 2 - 3, 3 - 2, 7 - 7], with the printer configured as
follows:

          Pers Prt = 2
          RS232, 9600, 8, 1, no parity, xon/xoff - rbst on
          Xmit Disable = No
          Busy Offl = No.

The last two parameters were the sticklers, and they're accessed through
the Setup:Misc menu.

Thanks to all those who responded,
Jeff Marans.

Technical Details

Message-ID: <1628@brchh104.bnr.ca>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!cunews!bnrgate!brtph3!brchh104!brchs1!bnr.ca!rice.edu!sun-spots-request

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!cunews!bnrgate!brtph3!brchh104!brchs1!bnr.ca!rice.edu!sun-spots-request
From: JEFF@vm.nrc.ca (Jeffrey Marans)
Newsgroups: comp.sys.sun
Subject: TI MicroLaser Hookup
Keywords: Hardware
Message-ID: <1628@brchh104.bnr.ca>
Date: 13 Feb 91 22:03:00 GMT
Sender: news@brchh104.bnr.ca
Organization: Sun-Spots
Lines: 15
Approved: Sun-Spots@rice.edu
X-Original-Date: Thu, 07 Feb 91 14:48:15 EST
X-Sun-Spots-Digest: Volume 10, Issue 38, message 9
X-Note: Submissions: sun-spots@rice.edu, Admin: sun-spots-request@rice.edu