🚀 go-pugleaf

Path: venice!lung
From: lung@venice.SEDD.TRW.COM (Diane M. Lung)
Newsgroups: comp.sys.sun
Subject: Re: Installing a 1.2G Fujistu Hard Drive on a SUN 4/330
Message-ID: <1087@venice.SEDD.TRW.COM>
Date: 10 May 91 21:45:59 GMT
References: <2848@brchh104.bnr.ca>
Organization: TRW Systems Engineering & Development Division, Redondo Beach, CA
Lines: 16

From article <2848@brchh104.bnr.ca>, by patrick@medicine.uchicago.edu (Patrick Goetz):
> Help!  We have been trying (unsuccessfully) to install a 1.2 Gigabyte
> Fujitsu M2266S on a SUN 4/330.  The machine simply doesn't "see" the hard
> disk.  All the obvious problems (inverted cable, wrong ID, bad
> termination, etc.) have been checked out, and the drive works fine when
> attached to a SPARC 1+ workstation.  Has anyone used this drive on a SUN
> 4/330 ?  Any ideas on what our problem is ?  We would greatly appreciate
> any help with this problem.  (Since I normally don't use Pnews, I would
> prefer that responses be sent directly to the address listed above.)

If anyone has a solution to this I'm interested too. We had the identical
problem on our 4/330 with a SUN-669 not too long ago. Because we couldn't
get it running, we ended up leaving it on the 1+ and NFSing.

Howie
howard%romulus@venice.sedd.trw.com