3D Modeling on SPARCS???

Article View: comp.sys.sun

Article #8564

#8564

From: Andy Rapo
Date: Thu, 27 Jun 1991 20:22

15 lines
925 bytes

I'm interested in knowing whether people consider
SPARCs a good platform for doing 3D modeling and
rendering.  I currently use a Silicon Graphics
4D/220, but have access to lots of Suns.  

What hardware/software combinations are available
for SPARC systems that would make them attractive
3D systems.  I would appreciate any opinions about
HOOPS, PEX and any other graphics software that
is out there.

Thanks a lot,
Andy Rapo
Cornell University
Simulation

Technical Details

Message-ID: <3870@brchh104.bnr.ca>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!cunews!bnrgate!brchh104!brchs1!bnr.ca!rice.edu!sun-spots-request

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!cunews!bnrgate!brchh104!brchs1!bnr.ca!rice.edu!sun-spots-request
From: rapo@cs.cornell.edu (Andy Rapo)
Newsgroups: comp.sys.sun
Subject: 3D Modeling on SPARCS???
Keywords: No Digest Subjects during Flush
Message-ID: <3870@brchh104.bnr.ca>
Date: 27 Jun 91 20:22:00 GMT
Sender: news@brchh104.bnr.ca
Organization: Sunspots, Flush Mode
Lines: 17
Approved: sun-spots@rice.edu
X-Original-Date:    Sat, 8 Jun 1991 05:49:47 GMT