Subsystem error input (Can't get an error)

Thread View: comp.sys.transputer

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Coert J. Vonk Tue, 11 Dec 1990 15:53

#1176

Author: Coert J. Vonk
Date: Tue, 11 Dec 1990 15:53

27 lines
1550 bytes

This may sound weird to your but "I can't get an error message."

We use a transputer farm, of which all modules are compiled in Halt mode.
The configurer is told to support this mode, and even the iserver is
aborts on an error signal.

The main point is that the root transputer doesn't seem to care about his
subsystem error input.  An error on the root transputer terminates the iserver
(as expected), but an error on every other transputer does not.  Although this
signal arrives at the root transputer's subsystem NotError input (probed this).

When I tried a configuration that used the ErrorDown instead of the subsystem
that performed as expected.  I can't use this configuration because MMS2
doesn't support it.

Did anyone cope with simular problems, or can you give me a hint?

ThanX in advance! Coert.


BTW: we use D705B (Toolset) and 3L Pascal v2.0.
...........................................
Coert J. Vonk        voice: +31 70 332.3614
C_Vonk@pttrnl.nl       fax: +31 70 332.7807
hp4nl!dnlunx!coert   where: the Netherlands
...........................................
#include <disclaimer.h>

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads