interface LS C with OCCAM

Thread View: comp.sys.transputer

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by "GORUR" Tue, 13 Mar 1990 03:57

#2922

Author: "GORUR"
Date: Tue, 13 Mar 1990 03:57

20 lines
1480 bytes

This message is for Mr.Ken Koontz.My message to him bounced ,so I was forced to post it on the net.

Ken,
	Nice to know that i am not alone in the battlefield..given my timeframe
i'd rather be not..
	we have VME 3/2 adaptor to connect B014 on the SUN 3/110.(Advised by 
inmos).My major concern is to have OCCAM and C  running on the system.One of 
our need is to be able to interface OCCAM code with C code..do you have any idea about it..does LS C support such an interface?is there any advantage with
source code over binary version other than better documentation..?
when i talked to Mr. Bailey at LS,i got the impression that LS C compiler is 
supplied on floppy disk rather than tape(for sun application).. i might be wrong
he says he is not sure about the interface question(OCCAM and C).I am confident
of getting the system (1 B014, 1 B404, 3 B411) to run with D505 and D514.
I would appreciate any comments.If i have any further questions, can i call you?
arun
database research center
univ of florida
gainesville,florida
vu2oak@pine.circa.ufl.edu
asg@beach.cis.ufl.edu

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads