Inmos/3L par C, flood fill: Help needed!

Thread View: comp.sys.transputer

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Klaus Kusche Mon, 26 Mar 1990 19:41

#515

Author: Klaus Kusche
Date: Mon, 26 Mar 1990 19:41

26 lines
1796 bytes

Dear Mailing List:

A question concerning the Inmos/3L Parallel C flood fill configurer:
* Must the link the whole network boots from (i.e. the link connecting
  the root transputer to the host) always be link 0 of the root
  transputer, or will the same (binary) code also work correctly on
  networks where the host is connected to link 1, 2 or 3 of the root
  transputer?
* If the code depends on the boot link, is there any way to change the
  default from link 0 to something else?

Any help appreciated!

************************************************************************
* Klaus Kusche                                                         *
* Research Institute for Symbolic Computation                          *
* Johannes Kepler University           Tel: +43 7236 3231 67           *
* A-4040 Linz                          Telex: (Austria) 22323 uni li a *
* Austria (Europe)                     Fax: +43 7236 3231 30           *
*                                                                      *
* Bitnet:           K312240@AEARN                                      *
* Arpa/CS/Internet: K312240%AEARN.BITNET@CUNYVM.CUNY.EDU               *
* UUCP:             mcvax!aearn.bitnet!K312240                         *
* Janet:            k312240@earn.aearn or k312240%aearn@earn-relay     *
************************************************************************

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads