🚀 go-pugleaf

I have a couple of dead 6085 workstations; one that I've acquired recently
and another that I've been using for Viewpoint (standard word processing).

Both machines will not boot;  the cursor code changes to 02-00.  I've 
also tried to boot off of the diagnostics floppy unsucessfully.  One
of the machines will eventually shut down power after around 10 minutes of
being hung in the 02-00 state.  I have checked the power (+5, +-12) and it
looks good with a voltmeter, no movement of the digits; I haven't checked with
an Oscope, but I suspect it is one of the other cards.

Has anyone run into this problem before?  Any suggestions?  Know what it 
means?  Any help would be appreciated.  You can either post or email.  The
problem looks like it may be "generic" as the workstations came from two
different parts of the country.

Thanks,
Mike Mazarick
mazarick@mcnc.org