🚀 go-pugleaf

   My thanks to everyone who responded to my question about updating the
Bad Page Table on an 1109.  The answer turned out to be:

	2-Boot or 5-Boot the fixed-disk diagnostic floppy.

	When you get a prompt, logon as user xerox with wizard
privileges.  I am not going to post the password, but you can probably
guess it from this message if you try.  If not, ask me directly.

	You might want to peruse the commands that are now available
by typing "?".

	One option now is to use the Manual Entry command to update
the Bad Page Table.  Another option is to use the Test Bad Pages
command.  This steps you thru each bad page and allows you to either
repair it or add it to the table.  (There is nothing complicated about
attempting a repair.  You just type "repair" and either it gets fixed
or it doesnt.)

   You can probably figure out the rest on your own.  I had some kind
of trouble when I tried to use the Media Scan command when logged on
as a wizard, so you might want to avoid doing that.  Dont take
anything in this message as Gospel since I only used it once, and I'm
writing this from memory anyhow.

   I hope this is useful (and not illegal for me to post).


   Twinerik