Re: Hard Disk in a Z-100

Article View: comp.sys.zenith.z100

Article #149

Back to comp.sys.zenith.z100 Previous Next

#149

From: Kent Phelps
Date: Wed, 21 Mar 1990 16:11

19 lines
1454 bytes

Perhaps I need to clarify my problem.  By not working right off the bat I
should have said that it doesn't run prep right off the bat.

I have a Z100 that has hard drive problems but I am not sure if it is the
controller boards or if the problem is the hard disk itself.  The unit passes
the controller diagnostics but as soon as I run any of the disk diags I get
a failure.  In the hope that the problem was a hard disk I tried to install
an ST-225 in its place.  When I try to run PREP ( MS-DOS Ver 2.1 ) I get an
error.  I know all the parameters for the ST-225 so that is no problem.  What
I need to know is if there are any jumper or switch changes I must implement
on the controller or the data separator.  The old hard disk is a 10 MByte so
that may be part of the problem.  Inquiring minds want to know.


Again - Thanx in advance.
--
     Kent Phelps        | Internet:  kent@sun.ufnet.ufl.edu
 University of Florida  | UUCP:  ... ????
 Digital Design Facility| Phone: 904-392-2464

Technical Details

Message-ID: <22724@uflorida.cis.ufl.EDU>

Path:

arc1-ca.pugleaf.net!utzoo!attcan!uunet!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!uflorida!sun.ufnet.ufl.edu!kent

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!uflorida!sun.ufnet.ufl.edu!kent
From: kent@sun.ufnet.ufl.edu (Kent Phelps)
Newsgroups: comp.sys.zenith.z100,comp.sys.zenith
Subject: Re: Hard Disk in a Z-100
Message-ID: <22724@uflorida.cis.ufl.EDU>
Date: 21 Mar 90 16:11:12 GMT
Sender: news@uflorida.cis.ufl.EDU
Reply-To: kent@sun.ufnet.ufl.edu (Kent Phelps)
Organization: UFNET
Lines: 19