z100 won't recognize hard disk

Thread View: comp.sys.zenith.z100

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Philip Arny Mon, 04 Mar 1991 16:57

#279

Author: Philip Arny
Date: Mon, 04 Mar 1991 16:57

26 lines
1631 bytes

Hell out there -- got a curious problem.  Just purchased an old z100
with a 10 meg hard drive.  The drive is a miniscribe 2012, attached to
a standard z100 hard drive controller (as far as I can tell).  Now,
this is the trouble.  Prep works fine; initializes and tests the
drive, completes with no errors (appropriate jumper had been set).
Part works fine (after jumper has been set back).  detect (also known
as verify) works fine.  All of them access the hard drive just fine,
the red light goes on, and they seem to read and write properly.
However, when I attempt to format the drive from Dos 2.1 (and 3.1) I
get a "not ready error reading drive E; abort, retry, fail?".  Any
ideas of what could be wrong?  There's a set of dip switches on the
controller card; I have no documentation, so I don't know if they
might be set wrong.  Help!  Copies of hardware documentation for the
z100 winchester system would be very helpful, as would any ideas or
suggestions.  Thanks!

Philip Arny
Bio-Med library
U of MN
lrccon@ux.acs.umn.edu
lrc1@umnhsnve

-- 

Philip Arny, Bio-Medical Library, University of Minnesota
lrccon@ux.acs.umn.edu or lrc1@nve.hscs.umn.edu or lrc1@umnhsnve.bitnet

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads