Re: Help with setup

Article View: comp.sys.zenith

Article #445

#445

From: LOUIS ISELIN
Date: Thu, 05 Nov 1992 18:38

17 lines
1162 bytes

In article <40526@sdcc12.ucsd.edu>, ee152fbw@sdcc15.ucsd.edu (Itoyoko) writes...
>Say, I bought some memory for my father's zenith, but I can't get
>the machine to recognize it.  The bios if mfm400 and on bootup
>it says that there is 7600k memory while setup reports 3300k, press
>esc.  Thanks
> 
>IY
> 
It sounds like you need to run setup and report the new memory there.
Reboot in the monitor program by pushing Ctrl-Alt-Ins and then typing
"setup" at the prompt.  Change the memory setup and save the new format
by following the directions on the screen.  The error messages should go
away after that.
Good luck,
Louis

sig?  What's a sig?

Technical Details

Message-ID: <5NOV199213385077@robot.nuceng.ufl.edu>

Path: arc1-ca.pugleaf.net!sparky!uunet!ukma!eng.ufl.edu!robot.nuceng.ufl.edu!glowboy

References: <40526@sdcc12.ucsd.edu>

Show Full Headers

Complete Article Headers

Newsgroups: comp.sys.zenith
Path: arc1-ca.pugleaf.net!sparky!uunet!ukma!eng.ufl.edu!robot.nuceng.ufl.edu!glowboy
From: glowboy@robot.nuceng.ufl.edu (LOUIS ISELIN)
Subject: Re: Help with setup
Message-ID: <5NOV199213385077@robot.nuceng.ufl.edu>
Summary: Try Ctrl-Alt-Ins for setup 
News-Software: VAX/VMS VNEWS 1.41    
Sender: news@eng.ufl.edu (Usenet Diskhog System)
Organization: Nuclear Engineering Sciences - Univ. of Florida
References: <40526@sdcc12.ucsd.edu>
Date:  5 Nov 1992 13:38 EST  
Lines: 17

Reply to Parent Message