Article View: comp.sys.zenith
Article #515Re: Low level of hard drive -- again...
From: John Harris
Date: Thu, 07 Feb 1991 21:21
Date: Thu, 07 Feb 1991 21:21
24 lines
1434 bytes
1434 bytes
In article <91037.192931DSP@MTUS5.BITNET> DSP@MTUS5.BITNET (David Paxson) writes:
>How about booting up with Zenith DOS 3.3, using PREP, and then when you have
>to reboot, boot with MS-DOS 4.0?
>
>Since it is a low-level format, it shouldn't matter what version of DOS you
>use.
>
>- David Paxson
More precisly. Boot off Zenith DOS 3.3+ floppy and run PREP.
Then run PART, to partition the disk, if needed.
RE-boot off MS-DOS 4.0 floppy and then format partitions.
Using MS-DOS 4.0 system on your boot partition.
In my experience, you should think about getting ZENITH DOS for a Zenith.
On the surface you may never have a problem with MS-DOS running on a Zenith.
But, I'd be wondering about possible pitfalls of doing so, is your data safe?
Will obscure MS-DOS commands work with Zenith's hardware?
John.
CAD Lab Supervisor
Portland State University
Technical Details
Message-ID:
<1480@pdxgate.UUCP>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!ogicse!pdxgate!eecs!johnhReferences:
<1991Feb6.025603.18402@usenet.ins.cwru.edu> <91037.192931DSP@MTUS5.BITNET>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!ogicse!pdxgate!eecs!johnh From: johnh@eecs.cs.pdx.edu (John Harris) Newsgroups: comp.sys.zenith Subject: Re: Low level of hard drive -- again... Message-ID: <1480@pdxgate.UUCP> Date: 7 Feb 91 21:21:09 GMT References: <1991Feb6.025603.18402@usenet.ins.cwru.edu> <91037.192931DSP@MTUS5.BITNET> Sender: news@pdxgate.UUCP Reply-To: johnh@eecs.UUCP (John Harris) Organization: Portland State University, Portland, OR Lines: 24