🚀 go-pugleaf

In article <1992Aug7.024641.6285@dartvax.dartmouth.edu>                         
pete@othello.dartmouth.edu (Pete Schmitt) writes:                               
                                                                                
>                                                                               
>I have a SuperSport 386SX Laptop.  I am attempting to use an ZDS expansion     
>box model ZA-3040-EB.  The cable is PN: ZA-180-91                              
>When I plug it in (with or without the ThunderBoard                            
>I'm trying to use) I get the following error when the system is turned on:     
>                                                                               
>At top of screen:                                                              
>+++ DISK ERROR: Bad disk controller! +++                                       
>                                                                               
>At bottom of screen:                                                           
>--- Errors found! Please press <Esc> to continue ---                           
>                                                                               
>After pressing <Esc> the system boots up as normal but I have no access to     
>COM1 or COM2.  The 120M harddisk works fine as does the floppy drive. COM2     
>is an internal modem which I can dial but cannot send characters over any      
>longer.  COM1 is normally a serial mouse and the driver fails to load.         
>                                                                               
>I don't have the manual for the expansion box, since I bought it second hand.  
>Can someone please help??                                                      
>                                                                               
>-pete                                                                          
>                                                                               
>--                                                                             
>Peter Schmitt, UNIX Systems Specialist, Computing Services, Dartmouth College  
>Email: peter.schmitt@dartmouth.edu                        Phone: 603-646-2085  
>******* Let us not give up meeting together, as some are in the habit *******  
>******* of doing, but let us encourage one another.    -Hebrews 10:25 *******  
>                                                                               
Is there a jumper on the motherboard? of the Exp. box.  If so, then this jumper 
may need to be set so that the other two pins are connected.  This will switch  
the exp. box between the old and new configuration, depending on which Superspo 
rt model you have it hooked to.  If not, or if switching it does not fix it,    
then you may want to try putting a tiny piece of celaphane tape over the bus    
connector for IRQ6 on your adapter board.  If you do not know which connector   
is IRQ6, please repost and I will look it up.                                   
Mike Long                                                                       
Iowa State University