🚀 go-pugleaf

I can not get my Diablo 630 RO to print with my A1000.  I'm afraid I don't
know much about hardware.  I have a cable with pins 1-8, 10-13, and 17-25.
The pins don't switch around. i.e. pin 1 at one end goes to pin 1 on the other
end.  How do I rewire this cable so I can print?  Using this cable I can not
even get garbage from the printer.



Diablo RS-232-C
PIN NOTES

1   Protective Ground
2   Transmitted Data
3   Received Data
4   Request to send (Always high when power is on)
5   Clear to Send
6   Data Set Ready (Must be Hi to receive data)
7   Signal Ground
8   Rcvd Line Sig Detect
11  (Printer Ready)
20  Data Terminal Ready

Amiga 1000 RS-232-C (From Amiga Hardware Manual, Apendix E)
PIN DIR STD NOTES
1        Y  Frame Ground -- do not tie to logic ground
2    O   Y  Transmit data
3    I   Y  Receive data
4    O   Y  Request to Send
5    I   Y  Clear to send
6    I   Y  Data set ready
7        Y  Signal Ground -- do not tie to frame ground
8    I   Y  Carrier Detect
9        n  ---
10       n  ---
11       y  ---
12       n  ---
13       n  ---
14       n  WARNING -5V
15   O   n  Audio Output
16   I   n  Audio Input
17   O   n  716 kHz clock
18   I   n  Asserting this OPEN COLLECTOR...will generate level 2 interupt
19       n  ---
20   O   y  Data terminal ready
21       n  WARNING +5V
22       n  ---
23       n  WARNING +12V
24   O   n  3.58 MHz colorburst clock
25   O   n  Amiga system reset
         ^
         |-----refers to whether it is standard or not
     
     
     
Thanks in Advance

Chris Seline

cjs@oberlin.edu		(internet)
scs7317%ocvaxa@vb.cc.cmu.edu   (bitnet)
ihnp4!oberlin!cjs		(uucp)