🚀 go-pugleaf

(Email bounced, reply follows)

In article <1991Jan5.015419.21084@brolga.cc.uq.oz.au>,
           exnirad@brolga.cc.uq.oz.au (Nirad Sharma) writes:
> I posted a while ago asking with the proper WYSE60 CRT file for use with
> Oracle (V5, SQLFORMS 2.0.21, SCO Xenix 2.3.2). The file I received seemed
> to be more or less right but I noticed that :
:
> 3	if I start typing during a screen draw the terminal will often start to
> 	  behave in a crazy manner as if I had pressed all sorts of stray keys.
:

I have worked with the WY-85 for several years (and the WY-185 for a
while too).  I vaguely remember talking to them once about problems that
happened if you typed while the terminal was receiving and displaying
data.  In fact, I remember that the 85 used to "lock up" for about a
second, then continue redrawing.  The manuals also state that getting in
and out of Set-up during data reception is not recommended.

My gut feel is that they simply may have done a poor job on this
throughout their product line.  I don't know the first thing about
your application, however, so there very well could be other causes.

For your sake, I hope I'm wrong, though.  Best of luck to you.

+----------------------------------+-----------------------------+ - - - - - -
|  Mike Cepek, Programmer/Analyst  |  Internet: CEPEK@MGI.COM    |
|  Management Graphics, Inc.       |     Voice: +1 612/851-6112  |  "Engage."
|  1401 East 79th Street           |  Operator: +1 612/854-1220  |
|  Minneapolis, MN  55425  USA     |       Fax: +1 612/854-6913  |
+----------------------------------+-----------------------------+ - - - - - -