Re: WYSE wy-75 setup question

Thread View: comp.terminals

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Russell E. Hoffman, II Wed, 22 May 1991 00:29

#1291

Author: Russell E. Hoffman, II
Date: Wed, 22 May 1991 00:29

11 lines
800 bytes

> [question on how to kill the keyclick on WY-75]

When running, try holding down shift and hitting the return key on the numeric
pad. This toggles keyclick on most Wyse models. You can then go into setup
mode and do a "SAVE ALL" to make the change permanent.

Cheers,

Russell Hoffman
rh2y+@andrew.cmu.edu
Carnegie Mellon University

Re: WYSE wy-75 setup question

#1292

Author: cepek
Date: Wed, 22 May 1991 14:43

17 lines
1332 bytes

In article <kcCPhPy00VpGEC1HZd@andrew.cmu.edu>,
rh2y+@andrew.cmu.edu (Russell E. Hoffman, II) writes:
>> [question on how to kill the keyclick on WY-75]
> 
> When running, try holding down shift and hitting the return key on the numeric
> pad. This toggles keyclick on most Wyse models. You can then go into setup
> mode and do a "SAVE ALL" to make the change permanent.

On a WY-85 terminal, instead hold down the _ctrl_ key and press enter
(aka return) on the numeric keypad.  The WY-185 also works this way.

 ,---------------------------------,___________________________
/  Mike Cepek, Programmer/Analyst / Internet: CEPEK@MGI.COM   /
\  Management Graphics, Inc.      \    Voice: +1 612/851-6112 \  "Engage."
/  1401 East 79th Street          / Operator: +1 612/854-1220 /
\  Minneapolis, MN  55425  USA    \      Fax: +1 612/854-6913 \
 `--------------------------------/___________________________/

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads