H19 dip switch info

Thread View: comp.terminals

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Russel Mar Fri, 18 Dec 1992 11:49

#1354

Author: Russel Mar
Date: Fri, 18 Dec 1992 11:49

36 lines
1338 bytes

(RE: Request for Info)
Lucky break;  I had my manual right by my keyboard, so I had to expend 
little effort.  Hope it helps:
S402 (Upper switch)
0       on (1) = block cursor
1       on = no key clack
2       on = wrap around (i.e. off (0) is discard past EOL)
3       on = auto LF on CR
4       on = auto CR on LF
5       on = ANSI (off=VT-52/Heath)
6       on = keypad shifted
7       on = 50Hz refresh (off=60Hz)
...normal for all switches to be off (0).

S401 (lower switch)
0-3 baud rate
4       parity enable
5       odd/even parity
6       normal/stick parity
7       half/full duplex
baud set as follows: (xxxx=switches 0-3, "1" is on)
n/a     0000
110     1000
300     1100
1200    1010
2400    1110
4800    0101
9600    0011

(I skipped the odder baud rates)
If memory serves, 0001 is 19.2k, but the screen tear is awful on a stock 
H-19 and is not supported.  2nd party mods and ROMS supported rates 
>9600.

--
Russel Mar (bbs.ruscal@tsoft.net)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads