VT100 control codes

Thread View: comp.terminals

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by the troglodyte killer Thu, 08 Oct 1992 08:07

#907

Author: the troglodyte killer
Date: Thu, 08 Oct 1992 08:07

9 lines
801 bytes

 
     Howdy, I'm sure you get alot of this, but could someone point
me in the direction of a good source for VT100 control codes?  I'm 
writing a WordStar clone for the local anti-vi'ers and would like
to get it to talk ANSI and VT100.  I've already written an ANSI
driver, but need the VT100 commands..
 
                                                      -- TTK

Re: VT100 control codes

#911

Author: John Martin
Date: Fri, 09 Oct 1992 04:21

19 lines
1412 bytes

In article <1b0q7eINN7ii@darkstar.UCSC.EDU>, ttk@ucscb.UCSC.EDU (the troglodyte killer) writes:

>     Howdy, I'm sure you get alot of this, but could someone point
>me in the direction of a good source for VT100 control codes?  I'm 
>writing a WordStar clone for the local anti-vi'ers and would like
>to get it to talk ANSI and VT100.  I've already written an ANSI
>driver, but need the VT100 commands..

I have seen a couple of requests for this, so I'll post my response:
You can FTP the list from cajal.uoregon.edu. The file if in \pub, and
is called vt100.escape.codes. There is also a compressed version,
vt100.escape.codes.Z, if you have access to the Unix uncompress program.

	-Hope this helps!

-- 
John Martin                                        johnm@cajal.uoregon.edu
Institute of Neuroscience,   University of Oregon,    Eugene, OR,    97402

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads