🚀 go-pugleaf

dirk@dksoft.incom.de (Dirk Koeppen) writes:

>I tried to install a DVI to Kyocera F-2010 converter on a friends machine
>today which did not work.

>First I used the hp LaserJet+ emulation of the Kyocera in conjunction
>with Bebee's dvijep converter. The result was quit strange, after 
>every word the Kyocera inserted a Form-Feed. The printed words itself
>were in perfect quality. The same driver works perfectly with the 
>LaserJet IIP.

You should look at the firmware-version. It is a well know problem
of older firmware revisions! Especially the old F1010 has this
problem, the F1010 has never got a new release without this problem.
I don't know the release status of the F2010. 
Our F1200's have the release 5.9-16. This release has the problem fixed!

Also it is very important to set the H5 parameter correctly, we set
it to "3" for XON/XOFF only. 

>				***
>Does anybody use or have a DVI to Kyocera F-2010 converter. The Kyo has
>several emulation modes, mainly Prescribe and hp LaserJet+. He has enough
>memory to hold a full-page 300 dpi graphic.
>				***

We use it in HP Laserjet Mode, i have modified Beebe's DVI-Jet, so that it
downloads the fonts prior to the page, and also to reverse the ordering
of the pages, due to the face-down stacker.
But with 5.9-16 it should work with the original Beebe driver. I use
the modified version because of an old F1010 we have to support.

Sincerely,
Klaus Steinberger


Klaus Steinberger               Beschleunigerlabor der TU und LMU Muenchen
Phone: (+49 89)3209 4287        Hochschulgelaende, D-8046 Garching, West Germany
BITNET:  K2@DGABLG5P            DFN:     k2@t30.physik.tu-muenchen.dbp.de
Bayerisches Hochschulnetz: k2@charly.bl.physik.tu-muenchen.de