🚀 go-pugleaf

I have an odd problem with the use of miniboxedpage.

As I understand it should be the same as minipage.

The test document is as follows.

--------------------------------

\documentstyle[a4wide]{report}

\input{boxedminipage.sty}

\begin{document}

\begin{minipage}[c]{10in}
hello
\end{minipage}

\begin{boxedminipage}[b]{10in}
hello
\end{boxedminipage}

\end{document}

-------------------------------

the error I get when I try to run it through latex is as follows

latex header.tex
This is TeX, C Version 3.14
(header.tex
LaTeX Version 2.09 <7 Dec 1989>
(/usr/local/TeX/lib/tex/inputs/report.sty
Document Style `report' <13 Nov 89>.
(/usr/local/TeX/lib/tex/inputs/rep10.sty)
(/usr/local/TeX/lib/tex/inputs/titlepage.sty))
(/usr/local/TeX/lib/tex/local_inputs/a4wide.sty
(/usr/local/TeX/lib/tex/local_inputs/a4.sty)) (boxedminipage.sty) (header.aux)
Overfull \hbox (313.11375pt too wide) in paragraph at lines 7--10
[]$[]$ 
! Use of \@ doesn't match its definition.
\boxedminipage ->\@if
                     nextchar [{\@iboxedminipage}{\@iboxedminipage[c]}
l.15 \begin{boxedminipage}
                          [b]{10in}
? h
If you say, e.g., `\def\a1{...}', then you must always
put `1' after `\a', since control sequence names are
made up of letters only. The macro here has not been
followed by the required stuff, so I'm ignoring it.

? x
No pages of output.
Transcript written on header.log.


Thanks in advance for any ideas.

Clive King

-- 
E cmk@aber (UK)          \S Clive King                   \V        \F 
M cmk@aber.ac.uk (inet)  \N Technical Support Group,     \O +44    \A +44 970
A ...!mcsun!ukc!aber-cmk \A Dept of Computer Science,    \I 970    \X 617172
I           (uucp)       \I University of Wales,         \C 622427