🚀 go-pugleaf

I would like the captions under tables to be limited in
horizontal extent to the width of the table. I think this looks
better than what I get by default. Also I have several small 
tables which I would like to squeeze onto one page. A sample
follows:

------------------------------------------------------
\documentstyle{article}
\begin{document}
\begin{table}[p]
% \begin{center}
\begin{tabular}{|c|c|c|}\hline
 24 & bladder & Initial \\ 
 hour & pump & value \\ 
\hline
\hline
            .69 &             .69 &             .66 \\
              .7 &             .69 &             .69 \\
              .8 &             .69 &             .69 \\
              .7 &             .69 &             .69 \\
              .7 &             .69 &             .69 \\
 \hline
\hline
\end{tabular}
% \end{center}
\caption{NO3 recovery (mg/l) from run 16327PL\label{XXX}}
\end{table}

\end{document}
------------------------------------------------------

Note that as is the caption is wider than the table-- how can I
get the caption (in a box?) just the width of the table. Table
widths may vary some. This LaTeX file was in fact written with
an awk script extracting raw data from a database file; I would
like to keep the process 'automated' rather than do hand-tuning
if possible.


Thanks in advance.
___________________________________________________________
|Mike Whitbeck             |                              |
|Desert Research Inst.     | mikew@wheeler.wrc.unr.edu    |
|POB 60220                 |                              |
|RENO, NV 89506            | 702-673-7348                 |
|__________________________|______________________________|