🚀 go-pugleaf

In article <494@sphere.mast.ohio-state.edu>, gae@sphere.mast.ohio-state.edu (Gerald Edgar) writes:
> In article <7865@boulder.Colorado.EDU> hartzell@boulder.Colorado.EDU (George Hartzell) writes:
> >Does anyone know how to make MacDrawII dump a drawing postscript
> >file?  I've tried...
> 
> After you click OK in the print dialog, WAIT ...
> ... THEN hold down F (or command-F) until ...
> comes up.  You have to be fast, ...
> (I may have the text of these boxes slightly wrong).
> 
> Apparently, the new MacDraw II 1.1 allows you to do some editing
> between the time you click "OK" and the time printing starts!!

Is this stuff in the Mac manuals?? I looked through a couple and
found lots of baby food and blank page area space, but no tech data!!

I paged all the way thru a couple of manuals, early MacDraw and another,
without finding out how to write the postscript and get the required
header file. I wouldn't have had to page thru if it had been in the
contents or the index, but it wasn't, and I couldn't believe it wasn't in
the manual. But then these were the first Mac manuals I went thru.
And the last.

The rest of who?
----------------------------------------------------------------------
	Bruce Langdon  L-472                langdon@lll-lcc.llnl.gov
	Physics Department                  14363%f@nmfecc.arpa
	Lawrence Livermore National Laboratory       
	Livermore, CA 94550                 (415) 422-5444
UUCP: ..{qantel,ucdavis,pyramid,harvard,topaz}!lll-lcc!langdon