🚀 go-pugleaf

I have been trying to get a sample program of Interviews/Unidraw compiled.
I extracted the schematic drawing demo that is on the ftp site an
(finally) got it compiled.  But when I run it I get that age old error message...
yup, you quessed it "Segmentation fault (core dumped)".  I don't know if
it is a problem caused by my compilation proceedure (unlikely, I'd probl'y
get a different kind of error), something in the source (unlikely, probl'y 
wouldn't compile), something wrong with CC, which is installed in a non
standard place (unlikely, it was used to compile and install iv, and I'd
probly get another error), problem with th instalation of Interviews/Unidraw
(possible, it's in a non-standard place too).  

If anyone has an idea what is going wrong for me, PLEASE let me know. 

Or if you have suggestions for a course of action, etc...



{krakatoa:49} a.out
Segmentation fault (core dumped)
{krakatoa:50} dbx a.out
Reading symbolic information...
Read 2000 symbols
program terminated by signal SEGV (no mapping at the fault address)
(dbx) where
Include__11ToolPaletteFP4ToolPCc() at 0x11a28
ReadCompTools__11ToolPaletteFv() at 0x11a00
Tools__11ToolPaletteFv() at 0x115b8
Interior__11ToolPaletteFv() at 0x114cc
__ct__11ToolPaletteFv() at 0x11094
main() at 0x22e8

-- 
     ____      ____      ____			Bill Shirley
    / ___|    / ___|    / ___|			bill@gothamcity.jsc.nasa.gov
   |_|omputer|_|ciences|_|orporation		_______________________________
    _             _     _			Opinions expressed are obtained|
   | |___     ___| |   | |___			by a room full of immortal apes|
    \____|   |____/     \____|			with unbreakable typewriters.  |
  						~~~~~~~~~~~DISCLAIMER~~~~~~~~~~~