🚀 go-pugleaf

>X-Envelope-to: comp-windows-interviews@shelby.stanford.edu
>X-VMS-To: IN::"comp-windows-interviews@shelby.stanford.edu"

1
14-OCT-1992 03:49:57.50
   1 00:00:00.00
15-OCT-1992 03:49:57.50
daemon@interviews.Stanford.EDU
juando@cnm.us.es

Received: from interviews.Stanford.EDU by ESEVVX.CICA.ES ; 11-OCT-1992 03:49:53.64
Received: by interviews.Stanford.EDU (5.57/Ultrix3.0-C)
	id AA27513; Sat, 10 Oct 92 19:51:08 PDT
Received: by interviews.Stanford.EDU (5.57/Ultrix3.0-C)
	id AA27174; Sat, 10 Oct 92 19:48:38 PDT
Received: by lurch.Stanford.EDU (5.57/Ultrix2.4-C)
	id AA20630; Sat, 10 Oct 92 19:46:42 PDT
Received: by shelby.Stanford.EDU (5.57/Ultrix3.0-C)
	id AA04669; Sat, 10 Oct 92 19:41:40 -0700
Received: by sparc0.brc.uconn.edu (5.65/1.34)
	id AA16631; Sat, 10 Oct 92 22:45:34 -0400
Date: Sat, 10 Oct 92 22:45:34 -0400
From: sriram@brc.uconn.edu (Chittathoor M. Sriram)
Message-Id: <9210110245.AA16631@sparc0.brc.uconn.edu>
To: comp-windows-interviews@shelby.stanford.edu
Subject: Unidraw Question


Dear IV Users,
	Suppose I have two Rectangular Components, how do I make sure that If I 
cut the Component which is positionally at a higher location than the other component, It should remove both the components. But if I remove the lower level 
component only that should get cut, not the higher level component. 

Thanks for your valuable time. 


Sriram