🚀 go-pugleaf

>In article <5440@lectroid.sw.stratus.com> iservice@sw.stratus.com (Ian Service) writes:
>
>-- 
>I seem to have a problem when running Pagemmaker 4 with lots of fonts installed,
>when I select fonts to change the  fonts I only get   about half of them (the first half) on the screen and there seems no way to scroll to the rest of them.
>>
>Am I doing something wrong, has anyone else seen this?

As suggested before, use type specs, or ^T.  Then type the first letter of the
font name that you wish to use.  The names will cycle thru all posible entries.

Example.  If you want to select copperplate, type  ^T, then C, until
Copperplate appears.  You may cycle thru several C named fonts to get to it.

This is the fastest way to get fonts, after the font list gets too long.
My system has 200+ fonts and the font selection list is almost useless
for anything over A.


-- 
----
Steve Warner   -  Fremont, CA, USA  etc...
replies to:  sun!indetech!stables!sw    (forget what the header says)