🚀 go-pugleaf

I'm having a problem with Windows 386.  I have a
new machine, Club American 333C (AMI Bios) with
a Sigma Laserview 19" monitor and an MSC PC Mouse II.

First problem: during Win386 setup, my machine is
not listed on the machine options, so I chose Compaq.
Installing screen drivers is a bit of a complex deal,
but Sigma provides an instruction sheet and a disk
with the Windows/386 drivers etc on it.  I install
the mouse drivers in the prescribed fashion.

I'm configured the right way, I think.  The behavior
is this.  I get in directory WIN386.  I start the
thing by typing WIN386.  The cursor goes down one
line, about a half second passes, and the screen
in cleared and I'm back at the DOS prompt (not very
useful, eh?).

I called Microsoft (it's Windows 386, v. 2.11); no
help there (nice person, but no help).  I called
Sigma, they tell me I have the latest version of their
stuff (the monitor is brand new).  I called Club American,
where so far nobody has gotten back to me (maybe they're
looking into it).

Any suggestions?  (By now, I don't even swear at the
way Windows installation has to be done anymore.)  I'm
up for anything.  Because I *have* to have Windows up
to do my job, I installed Windows 286 too, and that
works fine.


==Jess Anderson===Academic Computing Center=====Univ. Wisconsin-Madison=====
| Work: Rm. 2160, 1210 West Dayton St., Madison WI 53706, Ph. 608/263-6988 |
| Home: 2838 Stevens St., 53705, 608/238-4833   Bitnet: anderson@wiscmacc  |
==Internet: anderson@macc.wisc.edu====UUCP:{}!uwvax!macc.wisc.edu!anderson==