🚀 go-pugleaf

rb9a@watt.acc.Virginia.EDU (Raul Baragiola) writes:
> I have a Shamrock 386SX with 2MB RAM and SCSI drive. Windows works fine
> if I don't use a permanent swapfile. If I do, it still works fine with
> one or two applications open. Sometimes, when trying to open a new
> application I get the message:
> 
> General Failure error reading drive C
> Invalid COMMAND.COM
> Cannot load COMMAND
> System Halted

  I have a BSR 386SX formerly with 2MB of RAM and a *non*-SCSI 80MB
  Seagate drive that did the exact same thing!  I *don't* think it's a
  SCSI interface problem.  I believe it's an inherent limitation of
  Windows and its use of the permanent swapfile.

  I added 2MB of memory for a total system RAM of 4MB and created a
  permanent swapfile of about 8MB, and the system worked much better.
  However, I can *still* crash the system if I keep on firing up
  mulitple programs, especially ones that require a lot of system
  memory.  This does not happen when I use a temporary swapfile
  (probably because I haven't fired up enough programs to overload the
  20MB of contiguous disk space available for swapping).

  I've concluded that Windows is running out of swapspace and croaking.
  Can anyone confirm this?

--

  Stuart

  "La vida de paz."
	--Yolocamba-i-ta'

    UUCP: {hp-sdd, hp-pcd, csu-cs, edison, hplabs}!hpfcla!yoshida
Internet: yoshida%hpfcla@hplabs.HP.COM
   VOICE: (303) 229-2324