🚀 go-pugleaf

spr003%cluster@ukc.ac.uk (Jim Mansell) writes:

>When I run Procomm (using a PIF file) under Windows 3 on my 386 Viglen AT, the
>first attempt works OK but all subsequent attempts fail: the Procomm screen
>comes up OK but there is no answer from the mainframe connection. Any attempt
>to use a comms programme (Windows Terminal, WinQVT, Kermit-PC) also calls up 
>the screen display but gets no answer. A hard reset allows any of these
>programs to work, but once Procomm is used once the same problem occurs again.

>Procomm is configured to use Com2; other software can be configured to use
>Com2 without problems, so the port itself seems OK.

>The computer has Com1 to Com4 installed, with the 386 Enhanced options
>in Control Panel set to 'always warn'. 

>Any ideas as to what might be the problem? Procomm is such as useful program
>I would like to run it in preference to Terminal or WinQVT.

	I have had no trouble running Procomm through Com3 (my serial mouse
	is on Com1).  I needed to set Com3Base in system.ini, but after
	that it's worked like a champ.  (I agree with you, Procomm makes
	Terminal look like a VW.)


o-----------------------------------------------------------------------------o
| Anthony C. Garland, P.E.                                 Garland Consulting |
| 1373 S. Bonanza Alley,                                       (206) 387-6390 |
| Camano Island, WA 98292                               kelpie@nwnexus.WA.COM |
o-----------------------------------------------------------------------------o