🚀 go-pugleaf

In article <1990Nov21.191907.11099@sj.ate.slb.com> poffen@sj.ate.slb.com (Russ Poffenberger) writes:
> >1. I have two serial ports and my modem is configured to COM3. Terminal
> >  program from window would not run.  It give message "COM3 used by ...",
> >  etc.  Mskermit, Procomm and BitCom all seem to be able to dial etc., but
> >  you can not see anything on screen.  Without window, they all work fine.
> >  In Mskermit, set port=Bios3 seems the only way to make it work.  This 
> >  setting does not work very well (lose char.) even without window.
> >  
> Don't know.
> 
Try checking the IRQ setting on your modem.. Terminal will NOT work under Any
IRQ other that 3 or 4.   I am entirely sure that that is your problem because of
the fact that you are setting your port in kermit to BIOS 3.  Just find you 
modem manual and look at what jumpers indicate which IRQ you are using.  
REMEMBER THE COM/MODEM IRQ's MUST NOT CONFLICT with each other.  If you find 
that my solution is incorrect or that you can make it work on an IRQ other that
3 or 4 please email me and let me know how you pulled it off.  I have been 
struggling with the fact that kermit and terminal will not work with a non 3 or 4 IRQ.
-- 
Chris Tjon
      UUCP:     	...!uunet!plains!tjon        Box 5224 
      BITNET:   	tjon@plains.bitnet           Fargo ND 58105-5224  
      INTERNET:   	tjon@plains.NoDak.edu        701-232-7678