🚀 go-pugleaf

How do you cancel printing in draft mode?  I tried escape...
can't figure out how to do it.  When in the manual does it give
instructions, I can't find it (I have pocket guide and ms press book).

Table of contents.  Too bad it doesn't include the actual number of
pages that the table of contents itself takes.  I have to manually
set chapter 1 to begin at page 1 (new section) when my toc is 4 pages.
Is this correct?

Printing from page N to M.  I have a 4 page toc, 1 page title page so
chapter 1, logical page 1, starts at physical page 6.  If I select the
mouse on the screen, I see page 30 in the status bar.  But if I start
printing from page 30 to 40, it is not the same page 30!  This is
somewhat inconsistent.  Right?

Oh well, I still like it, even though I had to sit through a 60 page
accidental print request!!!(couldn't escape it)  What happened to
    AbortDocProc anyway.

/*----------- Thanks in advance... --------------------------------------+
| Peter C. Bahrs                                                         |
| The USL-NASA Project                                                   |
| Center For Advanced Computer Studies      INET: pcb@swamp.cacs.usl.edu |
| 2 Rex Street                                                           |
| University of Southwestern Louisiana      ...!uunet!dalsqnt!gator!pcb  | 
| Lafayette, LA 70504                                                    |
+-----------------------------------------------------------------------*/

logi