🚀 go-pugleaf

In article <1993Jan11.212905.383@syssrv.stgt.sub.org>  
oli@syssrv.stgt.sub.org  (Oliver Eichler) writes:
> 
> Hi Folks:
> 
> Da hat man nun nen DAT an der Kiste haengen:
> [...]
> Jan 11 18:44:53 syssrv mach: 
> 	WangDAT Model 3100 Rev 01.9 as st0 at sc0 target 2 lun 0
> [...]
> 
> Und was passiert:
> 
> Schritt 1: Platte sichern:
> 
> 	[/oli] # dump 0fs /dev/rst0 1000000 /dev/sd1a
> 
> Laeuft soweit ja auch praechtig:
> 
>   DUMP: Date of this level 0 dump: Mon Jan 11 21:35:30 1993
>   DUMP: Date of last level 0 dump: the epoch
>   DUMP: Dumping /dev/sd1a to /dev/nrst0
>   DUMP: mapping (Pass I) [regular files]
>   DUMP: mapping (Pass II) [directories]
>   DUMP: estimated 56839 tape blocks on 0.00 tape(s).
>   DUMP: dumping (Pass III) [directories]
>   DUMP: dumping (Pass IV) [regular files]
>   DUMP: 92.12% done, finished in 0:00
>   DUMP: DUMP: 56841 tape blocks on 1 tape(s)
>   DUMP: DUMP IS DONE
>   DUMP: Tape rewinding
> 
> So, nun der Test:
> 
> 	[/oli] # restore if /dev/rst0
> 
> und was kommt:
> 
>  Shell:		Tape/disk read error: I/O error
>  Console:	st: cmd = 0x8 sr_io_status = 2H
> 		    Sense key = 0x0  Sense Code = 0x0
> 
> [GROSSES] :-(((
> 
> Also, was mache ich falsch ?
> Wo liegt der Haken ?

mach mal
uriela> restore -i
/dev/rxt0: I/O error
dann restore if /dev/rst0
Dann funktioniert es!
Frage mich nicht warum...

so long
		*** perstoro ***
-- 
 ***********************************************************************
*| Wilhelm Schaefer| perstoro@uriela.in-berlin.de |   NeXTmail please! |*
*| NeXT EnTHUSIAST |   Voice +49 30 / 395 31 91   | DATA+49 30/39547 49|*
 ***********************************************************************