🚀 go-pugleaf

 In article <833564542_OASIS_@esteem.demon.co.uk>
  simon@esteem.demon.co.uk (Simon Daw) said:-

>Has anybody got experience of fitting the RSVE serial port accelerator from
>System Solutions to their Atari (STE)?
>
>I recently purchased RSVE, but have put off fitting it because the instructions
>are very poor.  In a nutshell the instructions are as follows:

>The question I have is: Where on the main board do I find VCC (5V) and GND?

I had my board fitted by a local store for a fiver but by the looks of 
things the GND is almost certainly the long track that goes around the 
outside of the board, I think it does say ground on it somewhere. The 
5V (I think) was actually taken from the floppy drive port, I'm not 
too sure but I've got a big wire going there and my HD Drive module is 
fitted onto the top of the floppy controller.
I think this is coreect but the usual "I didn't do it!" bit applies if 
your ST starts smoking like a big burning thing.


__

  ---------------------------------------------------------------------------  
      Paul Womar - Just your average Atari user on the verge of sanity.
             Mail: Paul@pwomar.demon.co.uk        IRC: Wo
		    Support sanity - Forget Microsoft
 ---------------------------------------------------------------------------