🚀 go-pugleaf

 In article <833635320_OASIS_@pcc-uky.campus.mci.net>
  thechyld@pcc-uky.campus.mci.net (Ronald J. Hall) said:-

>It goes as far as ATZ, the modem returns "OK", and then you can hear the
>dial tone from the modem but instead of dialing, it kicks back off and
>Oasis gives the message, "No Carrier"...

    What's happening if you type modem commands under the "tip" terminal
of NOS? Start Oasis/NOS, but don't dial, type "tip sl0" (sl0 or any name
of the iface declared in the attach command in STARTUP.NOS) and then type
some modem commands like ATZ, AT/, AT&V, etc... if the responses are good,
it's not a serial problem, perhaps a config one... like: have you a <CR>
set after the telephone number in DIAL.TXT?

    If you don't have serial communication with the modem... well, set
HSMODA6 like this in the auto folder: first DRVIN.PRG, second SCC.PRG
without changing any parameter from the original HSMODA6 archive... it
must work like that. The only changes I've made are bigger Rx/Tx buffers.

    I use my modem now at 57600 bps, setting it by the modem.cpx to 134.
In the attach command, I say 57600... but NOS only reports an "unknown asy
speed", it's the CPX setting the important one.
__

	/* Bruno Kozlowski 100710.1360@compuserve.com */
	/* -==- A happy Falcon owner from france -==- */