🚀 go-pugleaf

 In article <834220176_OASIS_@flinny.demon.co.uk>
  nclist@flinny.demon.co.uk (Flinny) said:-

> In article <834107310snz@myriad-s.com>
>  brian@myriad-s.com (Brian Dew) said:-
> 
>>Update
>>======
>>
>>Tried it... Now getting 3 bombs instead of 2, which I guess is
>>progress of a kind :)
>
>Yep but in the wrong way :)
>
>>Where is CAB looking for the data for the headers?
>
>2 lines in the default.cfg really.. just youe email address and the 
>smtp host line.. 
>
>>MAIL.TXT is being created, but is blank. Should it have headers already
>>in place when CAB first attempts to load the editor?
>
>Nope cab.ovl builds up the mail headers from the info in your 
>default.cfg
>
>>If so, could it mean that for some reason CAB is getting confused about
>>the location of the header data, presumably DEFAULT.CFG?????
>
>Yep.. clutching as straws now.. but where did you put the 2 lines to 
>do with email and smtp host? if they are not near the bottom of the 
>default.cfg ?
>I suggest between the irc pong message line and the http proxy lines 
>as below.
>
>IRCPONGMSG = <>F<><>L<><>I<><>N<><>N<><>Y<> 
>EMAIL = nick@flinny.demon.co.uk
>SMTP_HOST = post.demon.co.uk
>HTTP_PROXY=www-cache.demon.co.uk
>HTTP_PROXY_PORT=8080
>
>>No one else seems to be getting this, so I must have done something
>>"unexpected" somewhere...
>
>If i remember Guy had a problem until the day before release :)
>
>Nick.

I'm having the same symptoms as Brian running a similar setup. But..... I only
downloaded www131 at about five this morning and had a quick scan through the
instructions. I then just copied the new Cab files (app,ovl,rsc) into my old
setup. I edited default config to up ALLOCMEM to 210000 and bunged in me email
address and SMTP_HOST thingy. What's this about an editor? Do I need to define a
path to an editor in Default.cfg? What editor should I be using? I don't
remember seeing anything about it in the instructions, but then again I was half
asleep :-)  I suppose I should sit down and check everything out but any
guidance would be appreciated.

BTW I want to run my serial port at 38400. I've got the info on a mod that does
it with just one LS74 chip. Do I need to use HSmodem and if so how do I get the
MFP setup progie to alias the buad rate at 110 or whatever? (I wish I'd paid
attention at German lessons).

Exhausted but not entirely disheartened, Gaz.           
__


~~~~~~~~~~~~~~~~~~ <> <> <> <> <> <> <> <> <> <> ~~~~~~~~~~~~~~~~~~

              I  M  M  O  R  T  A  L     C  O  I  L  S

       e-mail to: gary@imco.demon.co.uk or phone 01480 497730

~~~~~~~~~~~~~~~~~~ <> <> <> <> <> <> <> <> <> <> ~~~~~~~~~~~~~~~~~~