RSVE serial port accelerator

Article View: demon.ip.support.atari

Article #1658

Back to demon.ip.support.atari Previous Next

#1658

From: Simon Daw
Date: Thu, 30 May 1996 00:00

28 lines
1517 bytes

Has anybody got experience of fitting the RSVE serial port accelerator from
System Solutions to their Atari (STE)?

I recently purchased RSVE, but have put off fitting it because the instructions
are very poor.  In a nutshell the instructions are as follows:

        - Cut pin 16 of the MFP from the main board
        - Connect TID Brown Wire to pin 16 of the MFP
        - Connect TUA Green Wire to pin 7 or pin 10 of the MFP
        - Connect +5V Red Wire to VCC (5V) on the main board
        - Connect GND Black Wire to GND on the main board

The question I have is: Where on the main board do I find VCC (5V) and GND?

I have an STE with the 48 pin MFP in DIL housing and I possess all the
cutting/soldering skills that I need - It's just that I'm not an electronics
expert and don't know where to find these points on the main board.

Thanks in advance!

Simon Daw  
__

  ---------------------------------------------------------------------------  
     simon@esteem.demon.co.uk
  ---------------------------------------------------------------------------

Technical Details

Message-ID: <833564542_OASIS_@esteem.demon.co.uk>

Path: arc1-ca.pugleaf.net!unknown!not-for-mail

Show Full Headers

Complete Article Headers

X-Google-Language: ENGLISH,ASCII-7-bit
X-Google-Thread: 112f4b,80b5e5d9fd27f5ea,start
X-Google-Attributes: gid112f4b,public
From: simon@esteem.demon.co.uk (Simon Daw)
Subject: RSVE serial port accelerator
Date: 1996/05/30
Message-ID: <833564542_OASIS_@esteem.demon.co.uk>
X-Deja-AN: 157637422
x-nntp-posting-host: esteem.demon.co.uk
reply-to: simon@esteem.demon.co.uk
newsgroups: demon.ip.support.atari