🚀 go-pugleaf

In article <832028378_OASIS_@ajrose.demon.co.uk>
           andrew@ajrose.demon.co.uk "Andrew Rose" writes:

] Having fiddled around a bit I've got a version which doesn't run under my 
] standard set-up, but on a slightly cleaner machine will run (after a 
] fashion). Do the writers know whether any of the following stops ICE from 
] running?:   STiK (not enabled)  Freedom  1st Guide  NVDI 4.11 R3
] 
] If not any of the above, any clues?
] 
] Also, when I have managed to log on (on my clean machine) I've got as far 
] as all logged in but then it sticks. This, I presume, is the clock on 
] problem on an STe, so I'll try that next, but I notive from the log-on 
] that I'm getting 9600 baud. But try as I might, I can't find the option in 
] ICE-NET to set baud rates. Where is it?


Hi Andrew,
I have had problems, hadn't thought as far as a possible conflict though.

There is no baud rate setting in ICE AFAIK. You can set it using a cpx
(I use fast_ser whichj is simpler than hsmodem and gives me all I want
from it), but the answer may be to set it in the dial string. If you are 
looking for 14400 then &N6 is the one (I think - check the manual). I use
&N14 on the courier and get no probs...

Happy days...
-- 
Dave B
-------------------------------------------------------------------------
                         daveb@mbha.demon.co.uk
-------------------------------------------------------------------------